Hi 43oh!
It seemed like there was some interest in my solid state relay board, so I figured I'd post up the design files. Because of liability reasons (being high voltage and what not) I can't produce this, but your welcome to get some boards made and solder them yourself. Be warned, soldering the heat-sinks to the board is VERY DIFFICULT! You'll need a board pre-heater, hot air, and some good flux.
Schematic:
triac_board.pdf 33.53KB
10 downloads
Design package (in EAGLE 6.5):
triac_board.zip 235.93KB
4 downloads
Cheers!