Since this board has been out for longer than the cc3200, maybe there is better hope for a network bootloader ?
I found a few discussions on it, but not much to go on, maybe the board is not popular enough, or the ones that figured out how to do it dont share :)
I would like to make the board boot info a bootloader area, preferably a energia sketch, which checks if thers a new firmware available and if so flashes it to the main program area before jumping there.
Preferably the boot area would be protected, but even if not theres still the rom bootloader that would allow to recover over usb as far as I understand.
I am looking for a ethernet arm chip to replace my old 8bit network controller, but without network update its not of much use.
Any help/hints/pointers very welcome.