Hi,
SOLUTION
They got to share the GND to work correctly...
PART ANSWER : (see original question bellow)
The bread board is powered by batteries. So i think it's maybe a problem between the powering of the launchpad and the breadboard. So i wired the VCC and ground to those of the launchpad and the display is correct on the serial. So it's a problem of voltage references or ground or something (i'm pretty new to electronic) so what can i do to send informations (debug) to energia through launchpad with external kit powered by batteries?
ORIGINAL QUESTION
I put a 2553 on a breadboard and I'm trying to use the energia console to display values. When the chip is on the board there no problem.
I connect RXD/TXD from the board with TXD/RXD on the chip. On the jumpers area on the board (J3) if I connect the upper pins RXD and TXD it did not workn if i connect the 1st upper pin RXD with the 1st lower pin TXD it kind of worked but with gibberish :
Send 1 : 24.50
Sensor 3
TØÿLoop
Send 1 : 24.50
Sensor 1
TáûüLoop
Send 1 : 24.50
Sensïr q
taÿLoop
Did I miss something?
Regards,