Hi,
I am thinking of a low power project using the f5529lp and the cc3100bp in energia. The f5529lp will continuously collect sensor data and store it in memory. The cc3100bp will be configured to start in AP mode and serve a simple page showing the data collected. I want to be able to put the cc3100bp into hibernate mode using a switch and wake it up using the same switch. This will allow the project to save power if the wifi is not needed.
I know there is the nhib pin which puts the cc3100bp in hibernate when driven low and wakes it up if high. I was wondering if somebody had a similar project and was able to programatically control the power state of the cc3100bp. From the WiFi examples I am able to start the AP and serve a page. My problem is once I put the cc3100bp into hibernate and wake it up i am able to connect to the AP but I cannot access page.
Thanks in advance for your help.