Dear All,
I would appreciate some help from you here.
I am using Energia v0101E0014 (v15)
The uploaded picture shown my 3200LP jumper setting.
The 3200LP is using SPI to talk to Cypress CY5FRAMKIT
(http://www.cypress.com/?docID=52945)
The Cypress kit is using its default 5V setting on jumper J5.
So I connect P3.1 (5V) to feed the Cypress power.
My Wiring for cc3200 is as below
CC3200 Signal Name
---- -------
P1.7 SCLK
P2.3 CS
P2.6 MOSI
P2.7 MISO
P2.1 GND
P3.1 5V
However I can't read/write data to it.
I was able to use the same kit in Arduino platform, so the kit is good.
Q1:
DO I need to anything special to the CC3200 default jumper setting in order to use the above SPI pin iterface?
Q2:
What is the CS pin number in Energia code if I use P2.3 as the CS ping? Is it number "8", "18" or ... ?
Thanks in advance.
