Howdy everyone,
Finally getting back to the microcontrollers.
I have been trying to get the MSP and ADXL to work together.
https://e2e.ti.com/support/microcontrollers/msp430/f/166/t/490264
I have been using this code and the ADXL from Adafruit they already has the pull up resistors on the board. From Adafruit example they are only using SDA and SCL and the 3v power.
The red LED is only supposed to be on if the sensor is in certain positions. But it's on all the time. And I can not get anything to come up on the terminal screen even though it says connected.
Has anybody else built one of these?
Any where to start with the terminal connectivity or seeing if the sensor is functioning? I tried connecting SCL and SDA to my logic analyzer, both just show high but no signal.
Thanks!
Merry Christmas to yall!
Sent from my XT1254 using Tapatalk
Finally getting back to the microcontrollers.
I have been trying to get the MSP and ADXL to work together.
https://e2e.ti.com/support/microcontrollers/msp430/f/166/t/490264
I have been using this code and the ADXL from Adafruit they already has the pull up resistors on the board. From Adafruit example they are only using SDA and SCL and the 3v power.
The red LED is only supposed to be on if the sensor is in certain positions. But it's on all the time. And I can not get anything to come up on the terminal screen even though it says connected.
Has anybody else built one of these?
Any where to start with the terminal connectivity or seeing if the sensor is functioning? I tried connecting SCL and SDA to my logic analyzer, both just show high but no signal.
Thanks!
Merry Christmas to yall!
Sent from my XT1254 using Tapatalk