Hi all
I am looking to develop a small, bread-boardable (and altoids-embeddable) development board for the msp430g2xxx-series a la the arduino pro/micro/nano.
My first prototype was a total botch-job, with everything in the wrong place, as well as an unstable crystal (layout and capacitance-issues, I think). Se bad photo below.
My second protype is on the way, but it still has a 4-pin SBW-interface with VCC, GND, TDIO(reset) and TCK(test). Although I do not usually use serial, I have decided that it would probably be a good idea to add. I have searched for a standard pin layout, and have discovered that there is none.
But I wanted to ask if there was some sort of almost-standard for a 6 pin SBW+serial interface?
And I am completely open to ideas for improving the design :-)
