Hi,
I'm newbie in low power mode.
I've seen a lot of examples but I'm not able to see a low current in LMP4 mode.
The lowest current I can see is about 90uA.
Is there a minimal working sketch in order to run LPM4 mode and wake up the microcontroller with an external interrupt and switch on a led?
My hardware is launchpad V1.5 with Msp430G2553. Both red an green leds are off.
I've removed all the jumpers (Vcc and uart, NOT rst and test) and my power supply is a battery at 3.5V.
Thank you for your help and sorry for this newbie question.