i use this code
void setup()
{
Serial1.begin(9600);
Serial.begin(9600);
pinMode(RED_LED,OUTPUT);
digitalWrite(RED_LED,HIGH);
delay(5000);
digitalWrite(RED_LED,LOW);
Serial1.write("AT");
delay(2000);
Serial1.write("AT+NAMEan");
delay(2000);
}
void loop()
{
if (Serial1.available()>0)
{
Serial.write(Serial1.read());
}
if (Serial.available()>0)
{
Serial1.write(Serial.read());
}
}
when i send "AT" in the serial monitor appears "OK"
when i send "AT+NAMEan" in the serial monitor appears "OKsetname"
when i send "AT+VERSION" in the serial monitor appears "OKlinvorV1.8"
I have seen many tutorials but that is not what happens, you can help me?
