Hi all,
After owning a Launchpad for a while now I am only really getting started properly. So far things have gone well working through the examples. I have however got a bit stuck and don't really know how to tackle the problem. I tried to load up the code for this project...
http://arduining.com/2013/07/10/launchpad-energia-and-stepper-motor/
The LP that I have came with a 2231 but I bought a few 2553's and dropped one into the Launchpad for this project. I copied the setup on the webpage above and tried too load the code via Energia. I have tried quite a few times now but without any luck. I have selected the 2553 via the "Tools" menu in Energia. My hardware set-up is identical to that on the above page.
I thought that I had accidentally killed my Launchpad but I refitted the 2231 and loaded "Blink" and "Fade" and all was well. I cannot load either of these two simple programs onto the 2553. I really am running low on enthusiasm right now and would be grateful for any help or advice with this.
If there is a plainly obvious error I am making please excuse my ineptitude but I cannot see it.